Bountiful chimney & flashing repair referrals
Stop recurring leaks around brick chimneys, dormers, and roof valleys. Submit your project details online to connect with an independent local roofer.
Shingles shed water across open slopes, but metal flashing is what keeps water out wherever a roof meets a vertical surface—a brick fireplace chimney, a stucco dormer, a second-story wall, a skylight curb, or an exhaust pipe. When a roof leaks during blowing rain or snowmelt while the shingles look fine, failed metal flashing is one of the most frequent culprits.
With Bountiful's median home year built of 1973 (U.S. Census ACS), thousands of local ranch, rambler, and split-level homes feature original brick masonry chimneys and stepped multi-level rooflines. Over decades of freeze-thaw snowmelt (roughly 58.7 inches of average annual snowfall in Bountiful–Val Verda, higher on the East Bench) and high-elevation summer heat:
A leak near a fireplace can come from roof-to-chimney flashing—or from cracked chimney crowns, spalling brick, or missing flue caps. An independent roofing contractor inspects the metal step flashing, counter-flashing, cricket, and surrounding underlayment, and lets you know plainly if a masonry issue also needs a chimney mason.
Roofing Repair Bountiful is an independent referral service, not a roofing contractor. Submit your details online at no charge and we route your inquiry to an independent local roofing professional serving Bountiful and Davis County.
Proper metal flashing repairs replace fatigued sheet metal and underlying waterproof membrane rather than masking gaps with temporary mastic.
Removing deteriorated tar patches, weaving new galvanized or aluminum step flashing into each shingle course, and tucking fresh counter-flashing into ground mortar joints.
Building or rebuilding an angled diverter behind wide masonry chimneys so snowmelt and leaves shed cleanly around the stack instead of damming up.
Installing individual L-shaped step flashing pieces along dormer and split-level sidewalls plus kick-out flashing at the eave to push runoff into gutters.
Replacing aged skylight apron, step, and headwall flashing with self-adhering ice-barrier membrane wrapped tightly up the skylight curb.
Re-flashing B-vent furnace stacks, storm collars, and kitchen or bath exhaust penetrations that dry out under Bountiful's elevated UV.
| Flashing repair scope | Published national benchmark | Third-party source |
|---|---|---|
| Minor flashing repair (pipe boot, flue storm collar, small apron reset) | $150 to $1,000 (typical lower end ~$395) | This Old House / Angi |
| Typical standard roof repair range | $395 to $1,971 (national average ~$1,150–$1,176) | Angi / HomeAdvisor |
| Moderate flashing rebuild (full chimney re-flashing, skylight kit, sidewall run) | $1,001 to $2,000 | This Old House / Angi |
| Complex flashing + decking or cricket rebuild (structural wood replacement) | $2,001 to $8,000+ | HomeAdvisor / This Old House |
Figures are third-party published national averages from Angi, HomeAdvisor, and This Old House, not contractor quotes. Steep East Bench pitches, tall two-story chimneys, stucco cut-ins, and rotted framing directly affect actual written quotes from an independent local roofer.
Connect with independent contractors who rebuild proper step and reglet counter-flashing instead of relying on short-lived caulk.
Local Davis County roofers work daily on mid-century brick chimneys, split-level sidewalls, and custom East Bench dormers.
Get a direct on-site look at whether moisture is entering through roof flashing or through weathered chimney brick and mortar crowns.
Share your flashing leak notes once with zero referral charge and zero obligation to hire.
Water staining near your fireplace, skylight, or second-story wall? Submit our online form to connect with an independent Davis County roofer.
Free — no obligations
Tell us your city and whether the stain sits near a brick chimney, skylight, dormer, furnace flue, or interior wall.
We pass your inquiry to an independent local roofing contractor experienced with Davis County flashing systems.
The contractor inspects the flashing seams, mortar reglets, cricket, and surrounding sheathing, then delivers a written estimate.
Check active Utah DOPL licensing (S280, R100, or B100) at secure.utah.gov/llv before approving any repair contract.